The most expensive and most endangered part is obviously the compressor, therefore is is always suitable to install an FCH heating for crankcases on outdoor aggregates. Because if the temperature of the grease oil in the crankcase low, the oil will start absorbing the refrigerant. Due to this, the compressor greasing isn´t sufficient, which significantly lowers the lifespan of the whole cooling unit. Very often, service technicians also deal with repairs or exchanges of heating cables in cooling chamber doorframes, heating of drainpipes from evaporators and others.
FCH – heater for compressor crankcases
It is a compact line of heaters, which can be easily and quickly installed directly onto most compressors. It is entirely waterproof and is fitted with a tin-plated copper braiding for better resistance.
C1S – silicone heating cord
It is a serial heating element with a defined resistance for 1 m of length. This cord is supplied in length and it is necessary to attach the cold feeds during installation. If the joints are not made properly, there is a danger of moisture getting inside and subsequent damage to the cable. If necessary, it is possible to fit the cable with a tin-plated copper braiding.
CSC2 – drainpipe heater
The CSC2 heater consists of a heating cable with a cold feed, fully integrated with the heating section on one side. The start of the cold feed is marked by a sign on the cable. The blind end is insulated by a vulcanized silicon mould. The cabel is equipped with a double silicone insulation, making it resistant to temperatures from -70°C to 200°C.
CSC2K – drainpipe heater with thermostat
The CSC2K heating cable derives from the CSC2 type, but in addition, it has a built-in thermostat at the blind end of the heating cable. The heater is designated for positioning in collecting tubs of heat pumps and in cooling chambers. The built-in thermostat initiates the heating based on the environment temperature, so the heater can function independently on the other devices.
FTS0 – heating cable with a constant output and silicone insulation
This type of cable is alwys powered from one end, and it is possible to shorten it at installation in multiples of 0.5m to a required length. Therefore, it is most often used in repairs and piece production. The cable is supplied in three output versions – 25, 40, 50 W/m and with the possibility of a tin-plated copper braiding.
